CIRRUS

The Cirrus comes with...
* Pre-slotted phenolic airframe
* G-10 fiberglass fins
* Pre-weighted solid nosecone
* 7.5" Payload Bay
* Piston ejection system
Ultra-light nylon parachute
* Pre-cut 6 oz fiberglass reinforcement cloth
* Explicit instructions

Don`t let its small size fool you, this is NOT a "model" rocket! In fact this rocket can attain higher altitudes than a 4 inch diameter rocket using a "K" motor; and at a small fraction of the cost. Think about it... If recording the highest altitude is your goal, why would you put a 2-ounce altimeter measuring 1.5" x 4" in a 20 pound behemoth to attain a lower altitude? See the Motor Specifications Chart in the Spec Sheet section of our website for performance information. This is not a "Skill Level 1" rocket kit. To keep a high velocity, minimum diameter rocket like this together during flight, several important construction steps must be strictly adhered to. But don`t worry, everything you need (except for adhesives and paint) is supplied with the kit. Very explicit, step-by-step instructions are supplied as well. 20 minute Finish Cure Epoxy (EPY-FINISHING) will be required in addition to your regular 5 minute epoxy (EPY-5MIN). A HAMR motor retainer is not recommended for the Cirrus kit as it will disturb the airflow by projecting beyond the sides of the airframe, negatively impacting the purpose of the Cirrus, low drag and high altitude.